Installing Left Engine Mount

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

The tightening specifications for the basic engine are stored centrally (→ 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS ).

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

Guide engine mount into the mounting provided for it.
Guide the engine mount guide pin into the groove provided for it -arrow- so that it can no longer pop out.

Fig 1: Guiding Engine Mount Guide Pin
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Press against the engine mount from below -arrow- and tighten the fastening nuts on the engine mount Connecting piece Nr.89 Pos.3 .

Fig 2: Securing Engine Mount (4WD Turbo Engine)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Place heat shield in installation position. Fit and tighten four fastening screws -arrows- for the heat shield.

Fig 3: Locating Screws On Heat Shield (Shows Removed Primary Catalytic Converter, But Left Primary Catalytic Converter Remains Fitted)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.