LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan GTS >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (96 - Lights, Lamps, Switches, Interior -- PANAMERA (970)) >> WM 966225 Teaching Remote Control (Except PANAMERA S Executive, PANAMERA Turbo Executive, PANAMERA GTS) >> Teaching Remote Control

Teaching Remote Control

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information 

All remote controls (keys) are required for teaching a DME, front-end electronics (front BCM), rear-end electronics (rear BCM), electronic steering lock (ELV) control unit or remote controls (keys) for example.

Remote controls (keys) that are not taught during this teaching procedure will no longer be recognized by the vehicle.

NOTE: Voltage drop
  • Risk of irreparable damage to control unit
  • Risk of damage to control unit
  • Fault entries in the control unit
  • Coding in the control unit is aborted
  • Malfunctions in control unit, even during programming

→ Prior to disconnecting the control unit, switch off ignition and remove ignition key.

→ Ensure that the power supply is not interrupted during programming.

→ Connect a battery charger with a current rating of at least → Nominal value: 40 A  to the vehicle battery.

Information 

The PIWIS Tester II 9818  instructions take precedence since the description may be different with later Tester releases.

The procedure described here has been structured in general terms. Different text or additional information may appear in PIWIS Tester II 9818  .

  1. Connect the PIWIS Tester to the vehicle and start it. Switch on ignition.
  2. Diagnostics  must be selected and opened.
  3. Select the Online teaching function  menu on the Start page.
  4. Select the required vehicle  and press [>>]. Vehicle data will be read out.
  5. The vehicle identification number (VIN) is displayed. Adapt the vehicle identification number if necessary.
  6. Enter the repair order number and press [>>].
  7. Enter the PPN user name and password and press [>>].
  8. Login is performed.
  9. The Tester displays the message Login successful  . Press [>>].
  10. Follow the instructions on the Tester to select the required menu.
  11. Once the teaching process is completed successfully, the Tester shows the following status, for example:

    2 keys taught

    Front BCM: taught

    ELV: taught

    Rear BCM: taught

    DME: taught

    Overall vehicle status: taught

  12. Press [>>].
  13. Press [EXIT] to exit the Online teaching function  and select the vehicle type  on the Start page.
  14. Function test: Lock, open and start the vehicle using all remote controls (hand-held transmitters).
  15. Press [F7] Read all fault memories and erase if required  and delete all faults.
scientia non olet · About LEMON Manuals