LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan GTS >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> 6X Body-Equipment Outside - General -- (95B) MACAN >> WM 6X00IN Working With PORSCHE 2-Component Window Adhesive (Except MACAN Sport Edition) >> Mixing Procedure (Handling Double Cartridge Press)

Mixing Procedure (Handling Double Cartridge Press)

CAUTION: → Observe the safety instructions of the individual adhesive set components.
NOTE:
  • In addition to this manual, observe the relevant job descriptions for body repairs! 
  1. Prepare cartridge components A and B -H5, H6-  .
    1. 1.1. Pierce the membrane in the nozzle connection of components A and B (aluminium cartridge) -H5-  with a screwdriver and widen the opening. Remove flanged cover on end of cartridge.
    G11984395
  2. Screw on mixing nozzle -H7-  .
    1. 2.1. Screw both cartridges onto the mixing nozzle.
  3. Insert mixing cartridge into the double cartridge gun.
    1. 3.1. Move pressure pistons back fully.
    2. 3.2. Insert double cartridge -H5, H6-  into the bonding gun -A-  .
  4. Press out adhesive.
    1. 4.1. Actuate the valve -arrow-  to move the pressure pistons out slowly until both components of the bonding material emerge at the mixing tube.
    2. 4.2. Wipe off emerging adhesive.
  5. Screw on processing nozzle -H8-  .
    1. 5.1. Screw processing nozzle -H8-  onto the mixing nozzle -H7-  .
  6. Align processing nozzle.
    1. 6.1. Turn the processing nozzle on the mixing nozzle until the illustrated position is reached.
      NOTE:
      • In this position, the closed surfaces must be visible at the horizontal mixing nozzle from above and below and the mixing blade of the mixer insert from the sides  .
    2. 6.2.
  7. Mix adhesive components.
    1. 7.1. Actuate the valve -arrow-  to move the pressure pistons out slowly until the adhesive is visible in the processing pipe.
      G11984396
  8. Affix car window.
    NOTE:
    • In order to ensure that the substance is completely mixed, apply a 30 mm long adhesive bead of fresh adhesive to a piece of cardboard before processing  .
    • The bonding material has an open time of → working time: 15 min, the bonding material must be applied and the window must be assembled within this time  .
    • Do not load bonded parts until hardening is complete! 
    • If the contents of the cartridge is not completely used up, the processing nozzle should not be removed until the adhesive has hardened on the cartridge. A new processing nozzle must be used for subsequent bonding work  .
      1. 8.1.
        G11984397
scientia non olet · About LEMON Manuals