LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (42 - Rear Wheel Suspension, Drive Shafts -- PANAMERA (970)) >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Except PANAMERA Executive, PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4 Executive, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Preliminary Work

Preliminary Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the wheel bearing housing is replaced: 

    Remove the relevant hub cap using puller hook 9229/1  and loosen axle nut (lock nut) -1-  before raising the vehicle. Operate the brake while doing this (2 mechanics required).

    Fig 1: Identifying Axle Nut (Front Axle)
    G09807615Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Raise the vehicle → 4X00IN LIFTING THE VEHICLE .
  3. Remove wheel → 440519 REMOVING AND REINSTALLING WHEEL .
  4. Remove rear brake disc → 465319 REMOVING AND REINSTALLING REAR BRAKE DISC → 465419 REMOVING AND REINSTALLING REAR BRAKE DISC (PCCB) .
scientia non olet · About LEMON Manuals