LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (46 - Brakes - Brake Mechanics -- PANAMERA (970)) >> WM 468519 Removing And Installing Spreader Device (EPB Actuator) (Except PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4 Executive, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Removing And Installing Spreader Device (EPB Actuator) >> Installing Spreader Device (EPB Actuator)

Installing Spreader Device (EPB Actuator)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information 

If new brake discs and/or new brake shoes are installed on the vehicle, they must be worn in before calibration (not PCCB!). → 468350 REWORKING PARKING-BRAKE SHOES 

If a new actuator was installed, it must be confirmed in the Porsche System Tester.

  1. Clean the actuator carefully so as not to damage the dust boots.
  2. Visually inspect the dust boots for cracks.
  3. Installation is performed in reverse order. Note: Do not twist brake shoe mountings when installing the actuator!

    EPB actuator to wheel carrier: Tightening torque 10 Nm (7.5 ftlb.) +60° 

scientia non olet · About LEMON Manuals