LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (94 - Lights, Lamps, Switches, Exterior -- PANAMERA (970)) >> WM 944455 Replacing Bulb For Number Plate Light (Except PANAMERA S Executive, PANAMERA Executive, PANAMERA 4 S Executive, PANAMERA Turbo Executive, PANAMERA Turbo S, PANAMERA Turbo S Executive, PANAMERA 4S Sport Edition, PANAMERA 4 Executive) >> Installing Bulb For Number Plate Light

Installing Bulb For Number Plate Light

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Incorrect handling of bulbs
↓
  • Risk of damage to bulbs and the bulb housing

→ Switch off ignition and remove ignition key.

→ Switch off the relevant loads when changing bulbs.

→ Only use bulbs listed in the bulb table.

→ Only install clean bulbs that are free of grease.

→ Always use a cloth or soft paper when working with bulbs.

→ Observe the safety instructions when changing a bulb in a Bi-Xenon headlight.

→ In certain states, it is compulsory to carry spare light bulbs.

  1. Guide the bulb into the sheetmetal holder at an angle and press it to the side -A-  .
  2. Engage the bulb into the sheetmetal holder on the opposite side -B-  .
    Fig 1: Installing Bulb Number Plate Light
    G09814827Courtesy of PORSCHE CARS NORTH AMERICA, INC.