| Lower control arm to wheel bearing housing |
M14 thread/always use new nuts following removal |
Tightening torque |
140 Nm (104 ftlb.) |
|
|
| Upper trailing arm to wheel bearing housing |
M10 thread |
Tightening torque |
45 Nm (33 ftlb.) |
|
|
| Brake cover plate to wheel bearing housing |
M6 x 14 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Holder to wheel bearing housing |
M6 x 16 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Drive shaft to wheel hub |
Step 1 (wheels suspended in the air, press brakes while tightening)/M16 x 72 thread/always use new screws or bolts following removal |
Tightening torque |
200 Nm (148 ftlb.) |
|
|
| Drive shaft to wheel hub |
Step 2 (wheels on the ground)/M16 x 72 thread/always use new screws or bolts following removal |
Torque angle |
180° |
|
|