| Drive shaft to wheel hub |
Step 1 (wheels suspended in the air, press brakes while tightening)/M16 x 72 thread/always use new screws or bolts following removal |
Tightening torque |
200 Nm (148 ftlb.) |
|
|
| Drive shaft to wheel hub |
Step 2 (wheels on the ground)/M16 x 72 thread/always use new screws or bolts following removal |
Torque angle |
180° |
|
|
| Drive shaft to transmission |
M10 x 20 thread/always use new screws or bolts following removal |
Initial tightening |
30 Nm (22 ftlb.) |
|
|
| Drive shaft to transmission |
M10 x 20 thread/always use new screws or bolts following removal |
Final tightening |
+90° |
|
|