LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan Base >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> 40 Front Wheel Suspension, Drive Shafts -- (95B) MACAN >> WM 404119 Removing And Installing Front Drive Shaft (Except MACAN Sport Edition) >> Removing And Installing Front Drive Shaft >> Installing front drive shaft

Installing front drive shaft

  1. Grease splines with a little Optimoly TA aluminum paste and insert drive shaft. When doing this, press the inner joint together fully.
  2. Installation is performed in reverse order.

    Observe specified tightening torques:

    Drive shaft to transmission: Initial tightening 30 Nm (22 ftlb.) Final tightening +90° 

    Drive shaft to wheel hub (Step 1: Wheels suspended in mid-air, operate brake while tightening): Tightening torque 200 Nm (148 ftlb.) 

    Drive shaft to wheel hub (Step 2: Wheels on the ground): Torque angle 180° 

scientia non olet · About LEMON Manuals