| Lower trailing arm to wheel bearing housing |
M14 thread/always use new nuts following removal |
Tightening torque |
140 Nm (104 ftlb.) |
|
|
| Lower trailing arm to front-axle carrier |
M12 thread/always use new screws or bolts and nuts following removal |
Initial tightening |
70 Nm (52 ftlb.) |
|
|
| Lower trailing arm to front-axle carrier |
M12 thread/always use new screws or bolts and nuts following removal |
Final tightening |
+180° |
|
|
| Level sensor to lower trailing arm |
M6 thread |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Spring strut to lower trailing arm |
M12 thread/always use new screws or bolts and nuts following removal |
Initial tightening |
90 Nm (67 ftlb.) |
|
|
| |
|
|
+90° |
|
|
| Spring strut to lower trailing arm |
M12 thread/always use new screws or bolts and nuts following removal |
Final tightening |
|
|
|
| Tie-rod ball to wheel carrier cone |
M12 x 1.5 thread/always use new nut following removal |
Tightening torque |
100 Nm (74 ftlb.) |
|
|