Removing Rear Wheel Housing

Information:  Drill out the connection point on one side only. Do not damage the plate underneath.

Fig 1: Rear Wheel Housing Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of rear wheel housing

Information:  Make sure to leave an overlap of approx 20 mm on the wheel housing.

Information:  Only make cuts in the top plate. Make sure not to damage the plate underneath when doing this.

1. Mark and make the required cut Distance: 20 mm 
   1. 1.1. Remove rear wheel housing.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing rear wheel housing

2. Remove remaining pieces of rear wheel housing.
   1. 2.1. Drill out spotwelds using spotweld drill  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing remaining pieces