LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Macan Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 63 Bumpers -- (95B) MACAN >> WM 635537 Disassembling And Assembling Rear Apron (Except MACAN Sport Edition) >> Disassembling And Assembling Rear Apron

Disassembling And Assembling Rear Apron

NOTE:
  • The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment  .
  • The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant  .
  • Some steps must be carried out automatically  .
  • Some of the repair illustrations show only one side of the vehicle  .
  1. Remove wire harness for ParkAssist. → 975919 REMOVING AND INSTALLING WIRE HARNESS FOR PARKASSIST
  2. Remove ParkAssist sensors -3-  . → 917519 REMOVING AND INSTALLING PARKASSIST SENSOR
  3. Unclip cover for towing lug -4-  and guide out bracket.
  4. Unscrew fastening screws -1-  for wheel covers.
  5. Remove wheel covers.
    G11984454

    Disassembling rear apron 

    Assemble in reverse order. Pay particular attention to the following: 

  6. Tighten fastening screws for wheel covers to the specified tightening torque. Tightening torque 2 Nm (1.5 ftlb.) 
scientia non olet · About LEMON Manuals