Preparing Bonding Surfaces: Hardening

The body structural adhesives used harden at temperatures of between → Minimum temperature: 18°C  and → Maximum temperature: 80°C  .

Information: 

Infrared heaters only heat small sections of the body and are therefore only suitable for minor repairs.

• Only use devices with temperature control, automatic distance measurement and measuring point display, e.g  . infrared heater WE xxxx or infrared heater WE xxxx  .

Hardening can be accelerated by heat (e.g. using an infrared heater or in a painting booth).

Do not put pressure on bonded parts until the required assembly strength is reached.