Installing Rear-End Well

Information: 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive  .
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed  .
• Do not begin bonding work until all materials and tools necessary for later repair work are available  .

1. Install rear-end well and check that it fits perfectly. Check gap dimensions. Refer to WM 6X00IN GAP DIMENSIONS .
2. Resistance spot-weld the rear-end well.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Installing rear-end well