Preparing Rear Closing Panel For Installation

Information: 

• Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
• The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
• Do not begin bonding work until all materials and tools necessary for later repair work are available. 

1. Fit in rear closing panel.
2. Drill holes for plug-welding using a drill bit with a diameter of Diameter: 8.0 mm  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Drilling holes

3. Prepare connection areas for bonding and welding.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Preparing rear closing panel

   Orange	Bonding + resistance spot-welding
   Green	Resistance spot-welding
   Blue	Bonding