Preparing Centre Side Member For Installation

Information:  Adhesive must not be applied to areas to be plug-welded or fully welded using inert gas.

1. Fit in centre side member.
   1. 1.1. Cut centre side member at the transitions to the body leaving an overlap of 30 mm.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Preparing centre side member 

2. Fit in centre side member again.
   1. 2.1. Make cuts through the centre side member and body in the overlap areas.
3. Prepare centre side member for bonding and welding.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Preparing centre side member