Removing Inner Side Member

Fig 1: Inner Side Member Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of inner side member 

Information:  Drill out the connection point on one side only. Do not damage the plate underneath.

1. Drill out spotwelds using spotweld drill  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing inner side member 

2. Drill out spotwelds on reinforcement -1-  using spotweld drill  .
   1. 2.1. Remove reinforcement.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Removing reinforcement 

3. Drill through spotwelds In area -A-  using spotweld drill 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing inner side member 

   Information:  Drill out the connection point on one side only. Do not damage the plate underneath.

4. Drill out spotwelds using spotweld drill   .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing inner side member 

5. Heat the marked bonding areas.
   1. 5.1. Remove inner side member.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Removing inner side member