Subsequent Work For Body Repairs

1. Release and remove vehicle from the straightening system.
2. Clean joint areas and sheetmetal flanges with a wire brush.
3. Prime joint areas and sheetmetal flanges with 2K primer.
4. Restore standard seal with body sealant. Refer to WM 5X00IN SEAM SEALS .

   Also seal the repair area carefully.

5. Paint repair area and adjacent surfaces, if necessary.
6. Restore standard underbody protection with underbody sealant. Refer to WM 5X00IN UNDERBODY PROTECTION .
7. Apply standard cavity preservation. WM 5X00IN CAVITY PRESERVATION . Also carefully apply cavity preservation to the repair area.
8. Install removed accessories in the repair area.

Model year as of 2014