| Threaded connection securing wheel to wheel hub |
M14 x 1.5 x 49 thread (do not grease screw) |
Tightening torque |
180 Nm (133 ftlb.) |
|
|
| Threaded connection securing TPM valve to wheel |
M5 thread (always replace screws and lock nuts after removal); counter at the valve body, make sure it does not turn! |
Tightening torque |
4 Nm (3 ftlb.) |
+/-0.5 Nm (+/-0.5 ftlb.) |
|
| Threaded connection securing wheel electronics to TPM valve |
(Replace screws and lock nuts after removal) |
Tightening torque |
4 Nm (3 ftlb.) |
+/-0.5 Nm (+/-0.5 ftlb.) |
|