Engine Wire Harness For Timing Case, Valve Cover And Sides
WARNING: This page is about a different car, the 2014 Porsche Cayenne, 2013 Porsche Cayenne, 2012 Porsche Cayenne, and 2011 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Wire Harness For Timing Case, Valve Cover And Sides Components Location With Torque Specifcation
Engine wire harness for timing case, valve cover and sides
TIGHTENING TORQUE SPECIFICATIONS
| 1 | Screw, M6 x 12 > Tightening torque 12 (9 ftlb.) Nm -- dang -- |
| 2 | Aluminium screw. M6 (wiring harness to chain housing cover) > Initial tightening 4 (3 ftlb.) Nm -- dang -- and > Final tightening 90° -- dang -- |
Wire harness assignment, naturally aspirated engine
Wire harness assignment, naturally aspirated engine
| 1 | Bar ignition module, cylinder 1 |
| 2 | Bar ignition module, cylinder 2 |
| 3 | Bar ignition module, cylinder 3 |
| 4 | Bar ignition module, cylinder 4 |
| 5 | Injector, cylinder 5 |
| 6 | Injector, cylinder 6 |
| 7 | Injector, cylinder 7 |
| 8 | Injector, cylinder 8 |
| 9 | Injector, cylinder 1 |
| 10 | Injector, cylinder 2 |
| 11 | Injector, cylinder 3 |
| 12 | Injector, cylinder 4 |
| 13 | Bar ignition module, cylinder 5 |
| 14 | Bar ignition module, cylinder 6 |
| 15 | Bar ignition module, cylinder 7 |
| 16 | Bar ignition module, cylinder 8 |
| 17 | Camshaft controller |
| 18 | Camshaft controller |
| 19 | Hydraulic valve for variable valve-lift control |
| 20 | Hydraulic valve for variable valve-lift control |
| 21 | Engine ground |
| 22 | Engine ground |
| 23 | Engine ground |
| 24 | Engine ground |
| 25 | Speed sender |
| 26 | Hall sender (phase sensor) |
| 27 | Hall sender (phase sensor) |
| 28 | Knock sensor |
| 29 | Knock sensor |
| 30 | Knock sensor |
| 31 | Knock sensor |
| 32 | Tank vent |
| 33 | Generator |
| 34 | Crankcase heating |
| 35 | Flow control valve |
| 36 | Oil pressure regulating valve |
| 37 | Water temperature sensor |
| 38 | Air-conditioning compressor |
| 39 | Oil level sensor |
| 40 | Oil pressure sender with oil temperature sensor |
| 41 | Electronic accelerator (throttle adjuster) |
| 42 | High-pressure sensor |
| 43 | Starter, terminal 50 |
| 44 | Starter, terminal 30 |
| 45 | Starter, terminal 30 |
| 46 | Generator, B+ |
| 47 | Transfer point on vehicle, B+ |
| 48 | Intake manifold switch-over valve |
| 49 | Vehicle/engine connection point |
| 50 | Vehicle/engine connection point |
| 51 | DME (DFI) control unit |
| 52 | Secondary-air pump |
| 53 | Load detection pressure sensor |
| 54 | Engine compartment temperature sensor |
| 55 | Map-controlled thermostat (electrically heated coolant regulator) |