LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2018 >> Cayenne Turbo >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> 42 Rear Wheel Suspension, Drive Shafts -- 92A Cayenne >> WM 421119 Removing And Installing Lower Trailing Arm (Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S E-Hybrid, Cayenne Turbo, Cayenne S Diesel, Cayenne (3.0)) >> Removing Lower Trailing Arm

Removing Lower Trailing Arm

  1. Loosen the threaded joint -1-  for the trailing arm -2-  on the wheel bearing housing -3-  and pull out the screw.
    Fig 1: Identifying Fastening Screw On Wheel Bearing Housing
    G09935334Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Mark the installation position of the eccentric screw -1-  in the rear axle housing -2-  (-A-  ).
    Fig 2: Identifying Marking For Eccentric Screw
    G09935335Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Loosen the eccentric screw -1-  for the trailing arm -2-  and pull it out of the rear axle housing -3-  .
    Fig 3: Identifying Eccentric Screw For Trailing Arm
    G09935336Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Loosen the fastening screw -1-  for the trailing arm -2-  in the front rear axle housing -3-  and pull it out.
    Fig 4: Identifying Front Fastening Screw
    G09935337Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Take the trailing arm out of the vehicle.

    Press it out of the guides using a suitable tool if necessary.

scientia non olet · About LEMON Manuals