| No. 1: Threaded connection securing steering gear to suspension subframe |
M12 x 1.5 thread (always replace screws and lock nuts after removal) |
Tightening torque |
90 Nm (67 ftlb.) |
+90° |
|
| No. 2: Threaded connection securing tie rod to pivot bearing |
M14 x 1.5 thread (always replace screws and lock nuts after removal) |
Tightening torque |
90 Nm (67 ftlb.) |
|
|
| No. 3: Threaded connection securing tie rod to tie-rod end |
M16 x 1.5 thread, lock nut |
Tightening torque |
90 Nm (67 ftlb.) |
|
|
| No. 4: Threaded connection for heat shield |
M6 x 16 thread |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| No. 5: Threaded connection securing axial joint to steering rack |
M18 x 1.5 thread, axial joint |
Tightening torque |
100 Nm (74 ftlb.) |
+10° |
|
| No. 6: Expansion hose to steering gear |
a/f 17 thread (a/f = wrench size 17) |
Tightening torque |
32 Nm (24 ftlb.) |
+/-4 Nm (+/- 3 ftlb.) |
|
| No. 7: Return line to steering gear |
a/f 17 thread (a/f = wrench size 17) |
Tightening torque |
32 Nm (24 ftlb.) |
+/-4 Nm (+/- 3 ftlb.) |
|
| Expansion/return hose to steering gear |
M6 x 12 thread |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| No. 8: Heat shield to steering gear |
M6 x 16 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|