Installing Padding For 1/3-Split Folding Rear Backrest
- Position the padding for the 1/3-split folding rear backrest together with the cover and wire harness on the seat frame.
- Secure the backrest cover -1-
to the side airbag holder -2-
at the front and rear.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Fit side airbag to the backrest frame.
- 3.1. Guide the holder -1-
for the side airbag -2-
into the guide -3-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 3.2. Screw in fastening screw -4-
and tighten to → Tightening torque: 9 Nm (6.5 ftlb.)
.
- Carefully pull the backrest cover -1-
over the covers -2-
on the headrest guide.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Connect the existing electric plug connections.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- 5.1. Plug in electric plug connection -1-
for seat heating -A-
and lock it -a-
.
- 5.2. Plug in electric plug connection -2-
for seat heating connection point -B-
and lock it -b-
.
- 5.3. Plug in electric plug connection -3-
for side airbag -C-
and lock it -c-
.
- 5.4. Clip the holder -4-
for the electric plug connections onto the seat frame -5-
.
- Clip in the wire harness -1-
at the holders -2-
on the seat frame.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Carefully fold the backrest cover to the rear -arrows-
and insert the piping -2-
over the entire length into the guide -3-
on the backrest frame → Seat piping
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Check that the piping -2-
on the backrest cover -1-
engages securely in the guide -5-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Pull the rear backrest cover -1-
down -A-
and close the Velcro fasteners -2, 3-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Clip in the rear trim panel at the top -1-
at the retaining clips -2-
(-arrow-
).
Courtesy of PORSCHE CARS NORTH AMERICA, INC.