Installing Cover For Front Backrest

Information 

• Fasten covering to the padding, starting from the middle  .
• Do so in the following sequence: middle, top/bottom, left/right  .

Information 

Replace expansion rivets and fixing clips during installation and do not re-use them.

1. Pull the cover and padding over the upper part and side bolsters -A-  .
2. Pull the cover and padding back between the seat surface and backrest -B-  .
3. Carefully guide in the top of the cover at the guides for the headrest.
   Fig 1: Fastening Backrest Cover To Padding

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Plug in electric plug connection for seat heating (if installed) -1-  (-A-  ) until the connector engages securely.
5. Guide in wire harness for heated seats and secure with a tie-wrap.
   Fig 2: Plugging In Connector For Seat Heating

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Fit plastic rivets -1-  .
   Fig 3: Engaging Cover In Cut-Out For Backrest Cover

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
7. Engage the cover in the cut-out for the backrest cover all the way around -arrow-  .
8. Engage restraining strap -1-  for the cover at the left and right.
9. Clip in rear seat cover -2-  .
10. Tighten fastening screws -3-  for ISOFIX clips -4-  .
    Fig 4: Identifying Restraining Strap And Screws

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.