Installing Front Seat

Information 

• Some of the repair illustrations show only one side of the vehicle  .
• Naturally, some steps also have to be performed on the opposite side of the vehicle as well  .

1. Place front seat in the vehicle and tilt it backwards.
2. Plug in electric plug connections for the driver seat -1, 2 and 3-  .
   Fig 1: Identifying Electric Plug Connections For Driver Seat

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Plug in electric plug connections for the passenger seat -1, 2 and 3-  .
   Fig 2: Removing Electric Plug Connections For Passenger Seat

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Fold the front seat forward -arrow A-  and align it on the seat frame with the centering pins -arrow B-  .
   Fig 3: Positioning Front Seat On Seat Frame

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Connect the battery → 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
   WARNING: Incorrect handling of safety bolts

   • Danger of injury
   • Loss of torque

   → Always use new fastening screws and nuts following removal.

   → Observe specified tightening torques.

   → Carry out a visual inspection of all re-used parts.

6. Move front seat all the way back. Screw in front fastening screws -4-  only until the seat rails are touching the seat console.
   Fig 4: Tightening Screws On Front Seat Rail

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
7. Move the front seat all the way forward and secure it to the seat console at the rear with the fastening screws -2-  by tightening them to Tightening torque 50 Nm (37 ftlb.) +/-7.5 Nm (+/-5.5 ftlb.) until secure.
   Fig 5: Securing Front Seat To Rear Seat Console

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
8. Carefully fit the rear caps -1-  .
   Fig 6: Identifying Caps On Rear Seat Rail

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
9. Move the front seat all the way back and secure it to the seat console at the front with fastening screws -4-  by tightening them to Tightening torque 50 Nm (37 ftlb.) +/-7.5 Nm (+/-5.5 ftlb.) until secure.
   Fig 7: Tightening Screws On Front Seat Rail

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
10. Fit the caps at the front -3-  on the seat rail.
    Fig 8: Identifying Caps On Front Seat Rail

    Courtesy of PORSCHE CARS NORTH AMERICA, INC.
11. Install seat belt mount.
    1. 11.1. Position seat belt mount -2-  on the retaining pin -4-  and pull upward until the retaining clip -3-  locks with an audible click.
       Fig 9: Identifying Seat Belt Mount On Front Seat

       Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    2. 11.2. Pull on the belt strap. The retaining clip -3-  must engage fully on the holder.
    3. 11.3. Push the cap -1-  over the seat belt mount -2-  and lock it. The label on the seat belt must be pushed into the cap when you slide the cover down.