Installing Backrest Frame

A second mechanic is required: 

1. First mechanic:  Fit backrest frame.
   1. 1.1. Fit backrest frame on seat frame.
   2. 1.2. Pull electric line through between the seat frame and seat padding.
2. Second mechanic:  Tighten two fastening screws -1-  for the backrest frame on both sides to Tightening torque 33 Nm (24 ftlb.) +/-3 Nm (+/-2 ftlb.)  .
   Fig 1: Identifying Screws Of Backrest Frame

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Engage the bracket -6-  from below -arrow J-  .
   Fig 2: Securing Bracket At Sides

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Tighten fastening screws -5-  to Tightening torque 7.5 Nm (5.5 ftlb.) +/-0.5 Nm (+/-0.5 ftlb.)  .
5. Fit fixing clip -7-  .
   Fig 3: Securing Cover At Rear

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Engage rear side cover -8-  on the seat frame -arrow K-  .
7. Fit two electric plug connections at the underside of the seat.
   Fig 4: Plugging Connector For Backrest Wire Harness

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.