Installing Gateway Control Unit

Information 

Always comply with the regulations for handling ESD-sensitive components!

• Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche  .
• The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed  .
• Never touch the electric pins and plug contacts  .

1. Position gateway control unit on the holder.
2. Tighten fastening screws -2-  . Tightening torque 1.5 Nm (1 ftlb.) 
   Fig 1: Installing Control Unit On Holder

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Plug in and lock electric plug connection -a-  .
   Fig 2: Locating Gateway Control Unit Connector

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Position holder on dashboard support -arrow A-  and tighten fastening screws -1-  . Tightening torque 6 Nm (4.5 ftlb.) 
   Fig 3: Fitting Control Unit Holder

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.