Installing Heating/Fresh Air Unit

Information 

Replace seals.

1. Installation is performed in reverse order.
2. Coat mounting pegs, guides and rubber sleeves with sliding compound before installation.

   Information 

   Observe the different tightening torques for the nuts.

3. Only valid for Panamera 4S Diesel (97A) without auxiliary heater (I-no. 9M0) 

   and 

   Panamera 4S Diesel (97A) excl. Sweden/Iceland (C09), Finland (C13), Norway (C21) and Canada (C36) 

   Tighten nuts to the prescribed tightening torque > Tightening torque 8 Nm (5.9 ftlb.)