LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (21 Exhaust Gas Turbocharging 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 219019 Removing And Installing Pressure Sensor (V6 MONOTURBO) >> Removing Pressure Sensor >> Installing Pressure Sensor

Installing Pressure Sensor

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1 Replace O-ring on pressure sensor.
    2. 1.2 Tighten screw on pressure sensor (for Centre intake-air distributor) to > Tightening torque 5 Nm (3.5 ftlb.) 
    3. 1.3 Tighten screw on pressure sensor (for charge-air cooler) to > Tightening torque 5 Nm (3.5 ftlb.)  .
scientia non olet · About LEMON Manuals