Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location |
Des... |
Type |
Basic val... |
Toleranc... |
Toleranc... |
| Screw for balance weight |
Replace following removal. |
Initial tightening |
40 Nm (30 ftlb.) |
|
|
| Screw for balance weight |
Replace following removal. |
Torque angle |
+ 90° |
|
|
| Screws for balance shaft end plate |
|
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|