Installing D-Pillar Trim Panel
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
After fitting the D-pillar trim panel, the rear lid seal must be positioned correctly over the D-pillar trim panel.
Information
Always use new bolts following removal.
- Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for screw on cover for belt guide: > Tightening torque 5.6 Nm (4 ftlb.)
Tightening torque for screws for D-pillar trim panel: > Tightening torque 5.6 Nm (4 ftlb.)
Tightening torque for bolts on D-pillar trim panel: > Tightening torque 12.5 Nm (9.2 ftlb.)