LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (43 Leveling System, Air Suspension, Damper Control 4.0L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 436637 Disassembling And Assembling Rear Spring Damper >> Disassembling And Assembling Spring Damper >> Assembling Spring Damper

Assembling Spring Damper

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit stop buffer -1-  and protective sleeve -2-  .
    1. 1.1 Fit protective sleeve -2-  on stop buffer -1-  .
    2. 1.2 Slide stop -1-  buffer with protective sleeve -2-  onto piston rod.
      G15860955Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Stop buffer and protective sleeve

  2. Slide supporting washer -1-  onto piston rod -2-  and check that the cut-out in the supporting washer is positioned correctly in relation to the piston rod.
    G15860956Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Support washer

  3. Fit shock absorber mounting -1-  .
    1. 3.1 Slide the shock absorber mounting -1-  onto the piston rod -3-  as far as the support washer stop.
    2. 3.2 Screw on the nut -2-  and tighten using >T10001 - shock absorber set  while at the same time holding back the multiple-tooth screw of the piston rod -3-  .

      > Tightening torque 53 Nm (39.1 ftlb.) 

      G15860957Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Shock absorber mounting

scientia non olet · About LEMON Manuals