Installing Valve Unit

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fit valve unit -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for valve unit
1. 1.1 Tighten fastening screws -2- . >Tightening torque 4.5 Nm (3 ftlb.)
Information

Check the following before installing the air line:
- Check that the cutting ring -1- and Voss threaded joint -2- are still on the air line -3- .
- Check that the air line is fitted correctly.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Checking air line

Only one marking -1- on the air line should be visible.

Pull the air line briefly against the insertion direction. If it cannot be pulled out, the air line is fitted correctly.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Checking that air line is fitted correctly
Fit air lines on valve unit -1- . The air line is assigned according to the imprint on the valve unit.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for air lines on valve unit
1. 2.1 Connect air lines and tighten Voss threaded joints -2- . >Tightening torque 2 Nm (1.5 ftlb.)
2. 2.2 Connect air lines and tighten Voss threaded joints -3- . >Tightening torque 3 Nm (2 ftlb.)
Connect and lock electric plug connection -2- on the valve unit -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connection on the valve unit
Fit heat protection panel -1- at the bottom.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Heat protection panel mounting