LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (82 Auxiliary Heating - Wagon -- 971 - PANAMERA (971)) >> WM, 827219 Removing And Installing Circulating Pump (Hybrid) >> Installing Circulating Pump

Installing Circulating Pump

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1 Tighten screw for circulating pump holder to > Tightening torque 8 Nm (6 ftlb.)  .
    2. 1.2 Tighten screws securing evaporator holder to the body to > Tightening torque 9 Nm (6.5 ftlb.)  .
    3. 1.3 Tighten nuts securing evaporator holder to the body to > Tightening torque 3.5 Nm (2.5 ftlb.)  .
scientia non olet · About LEMON Manuals