Assembling Heater

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

When ordering spare parts, bear in mind that there are different repair sets and sealing sets for diesel and petrol heaters.

Information

Check components for damage. Pay particular attention to the sealing faces on the components and any seals that may be stuck on.
Replace components with damaged sealing faces or seals.

Fig 1: Heater Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Component overview of heater

Assembly is performed in reverse order. Pay particular attention to the following:

Clean the various components before assembly.
Replace any seals.
Tighten all screws to the prescribed tightening torque.
1. 3.1 Screws -1- securing cover for electric motor to combustion air blower > Tightening torque 3 Nm (2 ftlb.)
2. 3.2 Screws -3- securing cover to combustion air blower > Tightening torque 3 Nm (2 ftlb.)
3. 3.3 Screws -8- securing cover for control unit to heat exchanger housing > Tightening torque 3 Nm (2 ftlb.)
4. 3.4 Screws -11- securing retaining clip to heat exchanger housing > Tightening torque 3 Nm (2 ftlb.)