Loosening Clutch Cover And Bearing

Information 

If the bearing cover is pressed out of place, the circlip cannot be introduced fully into the groove

1. Remove clutch cover and bearing.
   1. 1.1 Remove clutch cover using a rubber hammer and pull bearing -1-  off the clutch.
   2. 1.2 Move > P90014/7 - puller  for plate -4-  and half shells -3-  into the bearing seat.
   3. 1.3 Place handle -5-  over half shells -3-  .
   4. 1.4 If the half shells do not slip into the seating, gently tap in ring -5-  using a rubber hammer.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Using bearing tool

   5. 1.5 Counter with handle -5-  and turn screw -6-  clockwise until the bearing is pulled off.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Pulling off bearing