Installing Brake Booster
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
Information
Make sure not to damage the push rod boot when installing the brake booster.
Always replace the seal between the brake booster and body.
- Install brake booster.
- 2.1 Replace seal.
- 2.2 Carefully guide the push rod of the brake booster into the opening on the bulkhead.
- Screw in and tighten nuts on the brake booster. >Tightening torque 23 Nm (17 ftlb.) + 2 Nm (1.5 ftlb.)
- Screw in and tighten nuts on the brake lines. >Tightening torque 18 Nm (13 ftlb.)