Subsequent Work
WARNING: This page is about a different variant/trim than selected.
Information
- The use of an impact bolter is not permitted.
- The thread must be checked visually and may have to be blown out carefully using compressed air. Always wear protective goggles when doing this!
- Replace screws.
- Install rear brake calliper.
- 1.1 Tighten screws.
> Initial tightening 20 Nm (15 ftlb.)
> Final tightening torque angle + 70°
- 1.1 Tighten screws.
- Connect and lock electric plug connection for brake pad wear indicator -1-
.
Electric plug connection for brake pad wear indicator
Information
New disc brake pads require a bedding-in time of approx. 200 km (125 miles)! Only then do disc brake pads achieve their best friction coefficient and wear values! During this time, only press the brake fully at high speed in emergencies!
- Position disc brake pads by pressing the brake several times.
- Check brake fluid level.
- Fit rear wheels.