Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Brake disc Ø, front | 420 mm | ||||
| Brake disc Ø, rear | 410 mm | ||||
| Brake disc thickness, front | 40 mm | ||||
| Brake disc thickness, rear | 32 mm | ||||
| Thickness tolerance of brake disc, max. | 0.01 mm | ||||
| Effective brake disc Ø, front | 324.6 mm | ||||
| Effective brake disc Ø, rear | 340.8 mm | ||||
| Brake pad area per wheel, front | 330 cm2 | ||||
| Brake pad area per wheel, rear | 153.8 cm2 | ||||
| Pad thickness, front | Wear limit 2 mm | approx. 8.4 mm | |||
| Pad thickness, rear | Wear limit 2 mm | approx. 11.9 mm | |||
| Wear limit of front and rear brake discs | Measure using VAS 6813 test equipment. Note measuring prerequisites. New values/wear values and three measuring points are lasered onto the brake disc hub. Wear value reached: Replace PCCB brake discs on both sides of the axle. | Measured value | XX/XX Read value on brake disc hub |
||
| Thickness tolerance of brake discs (max.) | Measured value | 0.02 mm | |||
| Lateral runout of brake disc (max.) | Measured value | 0.03 mm | |||
| Lateral runout of wheel hub (max.) | Measured value | 0.03 mm | |||
| Lateral runout of brake disc when installed (max.) | Measured value | 0.06 mm |