Preliminary Work
WARNING: This page is about a different variant/trim than selected.
- Only for e-Hybrid vehicles:
Observe warning notes.
> Refer to the appropriate Service Information for General warning notes for working on the high-voltage electrical system
- Only for e-Hybrid vehicles:
Isolate the high-voltage system from the power supply and complete the relevant documentation.
> Refer to the appropriate Service Information for Isolating high-voltage electrical system from power supply/Starting high-voltage electrical system (AFES)
- Remove front anti-roll bar.
- Remove rear part of front wheel housing liner on both sides of the vehicle.
> WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER