Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Install front speed sensor.
> 451155 REPLACING FRONT SPEED SENSOR
Install connecting link for anti-roll bar.
> 407819 REMOVING AND INSTALLING CONNECTING LINK FOR ANTI-ROLL BAR
Install brake disc.
> 465019 REMOVING AND INSTALLING FRONT BRAKE DISC

> 465119 REMOVING AND INSTALLING FRONT PCCB BRAKE DISC
Tighten axle nut -1- . Operate the brake while doing this (2nd mechanic required).
On vehicles with all-wheel drive: > Tightening torque 460 Nm (340 ftlb.)

On vehicles without all-wheel drive: > Initial tightening 200 Nm (148 ftlb.) > Final tightening + 100°

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Axle nut (front axle shown)
If the wheel bearing housing was replaced: Perform suspension alignment.
> 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT