Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Tie rod to wheel bearing housing | Hexagon-head bolt, M12 x 1.5 x 85/always replace bolts following removal! | Initial tightening | 70 Nm (52 ftlb.) | ||
| Tie rod to wheel bearing housing | Hexagon-head bolt, M12 x 1.5 x 85/always replace bolts following removal! | Final tightening torque angle | + 90° | ||
| Tie rod to rear axle housing/servo motor for rear axle steering (toe eccentric adjuster) | Eccentric screw, M12 x 1.5 with eccentric washer and hexagon nut | Tightening torque | 100 Nm (74 ftlb.) |