LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (21 Exhaust Gas Turbocharging 4.0L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 213019 Removing And Installing Turbocharger (V8 BITURBO) >> Subsequent Work

Subsequent Work

WARNING: This page is about a different variant/trim than selected.
  1. Install pressure pipe.

    > WM, 214119 REMOVING AND INSTALLING PRESSURE PIPE (V8 BITURBO)  "INSTALLING "

  2. Install intake manifold.

    > WM, 212419 REMOVING AND INSTALLING INTAKE PIPE (V8 BITURBO)  "INSTALLING "

  3. Install oxygen sensor on the turbocharger.

    > 246919 REMOVING AND INSTALLING OXYGEN SENSOR UPSTREAM OF CATALYTIC CONVERTER (V8 BITURBO)

  4. Install primary catalytic converter at the right.

    > 267619 REMOVING AND INSTALLING PRIMARY CATALYTIC CONVERTER (V8 BITURBO) - SECTION ON "INSTALLING"

  5. If the turbocharger on bank 5-8 was removed, position and tighten the connecting clamp for the primary catalytic converter at the left (bank 5-8).

    > Tightening torque 7 Nm (5 ftlb.) +/- 1 Nm (0.5 ftlb.) 

    1. 5.1 Then install the turbocharger on bank 1-4.
  6. Checking engine-oil level.

    > 170101 CHECKING ENGINE-OIL LEVEL

  7. Check engine coolant level.
scientia non olet · About LEMON Manuals