Installing Radiator

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
Check rubber mountings -1 and 2- for damage and replace them if necessary.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rubber mount

Tightening torque for screws securing condenser retaining frame to radiator: > Tightening torque 5 Nm (3.7 ftlb.)

Tightening torque for screws securing coolant distributor tubes to radiator: > Tightening torque 9 Nm (6.5 ftlb.)

Tightening torque for clamp securing pressure hose to charge-air cooler: > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.3 ftlb.)