Technical Values

WARNING: This page is about a different variant/trim than selected.

Location	Description	Type	Basic value	Tolerance
Fastening screws securing highvoltage line to power electronics	-2-	Tightening torque	8 Nm (6 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. High-voltage line from power electronics to high-voltage battery at power electronics
Fastening screw for ground line for power electronics, top	Item 3	Tightening torque	20 Nm (15 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Ground line for power electronics, top
Fastening nut for positive cable for power electronics, bottom	Item 3	Tightening torque	20 Nm (15 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Ground line for power electronics, bottom
Front axle carrier to body front	M12 x 1.5 x 90 thread/always replace bolts following removal.	Initial tightening	70 Nm (51.6 ftlb.)
Front axle carrier to body front	M12 x 1.5 x 90 thread/always replace bolts following removal.	Final tightening	+ 180°
Front axle carrier to rear body	Hexagonhead bolt, M10 x 45	Tightening torque	50 Nm (36.9 ftlb.)
Mounting anti-roll bar to body	M12 x 1.5 x 90 thread/always replace bolts following removal.	Initial tightening	70 Nm (51.6 ftlb.)
Mounting anti-roll bar to body	M12 x 1.5 x 90 thread/always replace bolts following removal.	Final tightening	+ 180°
Strut with mounting anti-roll bar to body	M12 x 1.5 x 90 thread/always replace bolts following removal.	Initial tightening	70 Nm (51.6 ftlb.)
Strut with mounting anti-roll bar to body	M12 x 1.5 x 90 thread/always replace bolts following removal.	Final tightening	+ 180°
Strut to body	Hexagonhead bolt, M10 x 25/always replace bolts following removal.	Initial tightening	50 Nm (36.9 ftlb.)
Strut to body	Hexagonhead bolt, M10 x 25/always replace bolts following removal.	Final tightening	+ 45°
Steering column centre to power-steering gear (universal joint)	Hexagon roundhead bolt, M8 x 30/always replace bolt following removal!	Initial tightening	20 Nm (15 ftlb.)
Steering column centre to power-steering gear (universal joint)	Hexagon roundhead bolt, M8 x 30/always replace bolt following removal!	Final tightening torque angle	+ 90°
Ground line to front PDCC (EAWS) control unit	Item 1: Internal hexagon roundhead bolt, M5	Tightening torque	5.6 Nm (4 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Disconnecting ground lines
Fastening screws securing engine mount to bracket	M10 x 45	Tightening torque	55 Nm (41 ftlb.)
Fastening screw securing engine mount to front axle	M12 x 60 x 1.5	Initial tightening	70 Nm (52 ftlb.)
Fastening screw securing engine mount to front axle	M12 x 60 x 1.5	Final tightening	+ 90°
Screw-type clamp for pressure hose		Tightening torque	5.5 Nm (4 ftlb.)	+/- 0.5 Nm (0.3 ftlb.)