Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Connecting rod bolts | Initial tightening | 50 Nm (37 ftlb.) | |||
| Connecting rod bolts | Final tightening | + 90° | |||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Final tightening | + 90° |