Installing Torque Support
WARNING: This page is about a different variant/trim than selected.
- Move torque support -1-
into installation position.
- Fit and -2-
tighten new screws M10 x 70 and M10 x 80.
> Initial tightening 50 Nm (36.9 ftlb.)
> torque angle + 90°
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Torque support - V8 Turbo
- Secure the strut -4-
.
- 3.1 Screw in and tighten screw -5-
.
> Initial tightening 20 Nm (15 ftlb.)
> Final tightening + 90°
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Screws for strut