Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Banjo bolt for oil spray jet | Initial tightening | 10 Nm (7.5 ftlb.) | |||
| Banjo bolt for oil spray jet | Final tightening | + 45° |