Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Screws on coolant control valve | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screws securing generator bracket to crankcase | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screws securing generator bracket to crankcase | Replace following removal. | Final tightening | + 90° | ||
| Screw securing tensioning roller for air-conditioning compressor to air-conditioning compressor bracket | Tightening torque | 25 Nm (19 ftlb.) | |||
| Aluminium screw securing air-conditioning compressor bracket to crankcase | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Aluminium screw securing air-conditioning compressor bracket to crankcase | Replace following removal. | Final tightening | + 90° | ||
| Screw for deflection roller (generator) | M8 x 16.9 x 65 x 50 | Tightening torque | 25 Nm (19 ftlb.) | ||
| Screw securing shaft cover to oil guide housing | M6 x 16 (2 ea.) | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Final tightening | + 90° | ||
| Banjo bolt for oil spray jet | Initial tightening | 10 Nm (7.5 ftlb.) | |||
| Banjo bolt for oil spray jet | Final tightening | + 45° | |||
| Screws on return line adapter | Tightening torque | 9 Nm (6.6 ftlb.) |