LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2017 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (10 Engine - Crankcase, Suspension 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 100119 Removing And Installing Engine >> Subsequent Work >> Subsequent Work For Diagnostic Scopes

Subsequent Work For Diagnostic Scopes

WARNING: This page is about a different variant/trim than selected.
  1. Connect tester to the vehicle and start it.
  2. Switch on ignition.
  3. Start diagnostics.
  4. Select engine electronics (DME) control unit.
  5. Select Maintenance/Repairs  tab:
    1. 5.1 Only for hybrid vehicles: Decoupler commissioning without part replacement 
    2. 5.2 Only for V6T and V8T: Working on the high-temperature coolant circuit: Draining and filling coolant 
    3. 5.3 Only for V6T and V8T: Working on the high-temperature coolant circuit: Bleed cooling system 
    4. 5.4 Only for V6T and V8T: Checking oil level 
    5. 5.5 Only for reconditioned engine: Performing throttle valve  adaptation.
    6. 5.6 Only for reconditioned engine: Reset sensor wheel adaptation 

      → 287319 REMOVING AND INSTALLING PULSE SENDER

    7. 5.7 Only for reconditioned engine V8Tevo: Writing adaptation of camshaft sensors 
  6. Select the Drive links/checks  tab and reset under Learning values 
    1. 6.1 Only for replacing injector valves and reconditioned engine: Reset injector valve learning values 
    2. 6.2 Only for R4: Resetting chain elongation 
    3. 6.3 Only for R4: Replacing turbocharger and reconditioned engine: Reset, turbocharger learning values 
  7. Read out all fault memories  , process and delete existing faults if necessary.
  8. Exit the diagnostic application. End operational readiness on the vehicle. Disconnect tester from the vehicle.
scientia non olet · About LEMON Manuals